Installation involves raising a separate, spring-loaded, plastic collar/latch for each cartridge, inserting them face out, and then closing and securing the latch. Installing the ink cartridges was not difficult, but the cartridges, which are small house-shaped plastic boxes, are unlike other printer manufacturers' cartridges, so there might be a small learning curve. The total time for physical setup was approximately 10-15 minutes from the time the box was opened to being ready for software installation. Unpacking the printer, loading paper, connecting the power cord, and installing the software was an easy process. If necessary, this snaps on easily, and the printer is virtually ready to go out of the box. The test unit came fully assembled, although it is possible that other C5180 printers may be shipped with the control panel faceplate unattached. HP does a good job with using recycled and recyclable packaging. The power supply and cord comes in the box along with a setup guide, basics guide, installation CD, and 1-year limited warranty. The design is simple featuring lots of graphics and large type, leading the user through unpacking the printer, loading paper, installing the ink cartridges, and installing software and drivers.īesides the HP Photosmart C5180 printer itself, the package includes six ink cartridges: black (16 ml), cyan (4.5 ml), magenta (4.5 ml), yellow (4.5 ml), light cyan (4.5 ml), and light magenta (4.5 ml). The Setup Guide makes the setup process very easy. Here's the link to the HP forums with our posts: Īlso.Introduction Setup / Drivers and Software just figured this would help out other HP owners with a power cycling issue. So I busted out my 25W plug in iron that was included with a computer repair kit from the 90s since it had a fine point tip. Then my butane powered iron's tip was way too big for soldering this kind of stuff. The solder wick sucked up excess solder, but didn't release the capacitor's pins from the circuit board. Desoldering sucked and didn't work at all like all the howtos I read. They arrived today, and I worked on replacing them. I bought two of each cap in case I messed something up since I've never soldered on a circuit board before. So I researched some more about replacing capacitors (mostly on motherboards), and the consensus was that voltage didn't really matter much on electrolytic capacitors (as long as it was higher than needed), but you needed to match the uF rating, or risk having some weird issues. Both were from the same manufacturer, and both had the lowest voltage ratings of all the caps on the board. Sure enough, I had two bad capacitors on my power supply board. Pretty much creating a giant paperweight.įinally found a post on the HP support forums by pcully, who included a link to this site and an explaination+picture of what a bad capacitor looks like. Sometimes the exclamation point would light up when it was cycling. would just power cycle non stop displaying the HP logo and loading bar on the screen the whole time. Then finally it stopped turning on at all. It was able to be cleared up with a hard reset, but would always come back after one print job. I have an HP Photosmart C5180, and after about 4 years of light use, it started displaying "ink system failure". Just wanted to post on here a solution to an issue that many people are having with their HP all-in-one multifunction printer/scanner/copiers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |